Getting Started 2-9
W A R N I N G
When connected to the alarm out connector, you must use safety
certified equipment and/or power sources.
Filter Scanner
This connector is used with the optional TSI Electronic Filter Scanner
(TSI P/N 700103). Plugging in the connector from the Electronic Filter
Scanner allows you to start and stop a sample from the probe head. In
addition, the alarm for exceeding a given level can be heard at the probe
as well as from the instrument.
Probe
This connector is used with a variety of TSI velocity/temperature/
humidity probes such as those listed below. The probe is plugged into
this port with the power off. When a probe is connected to the instrument,
additional velocity, temperature, and relative humidity information is
displayed on the top, center of the main screen as well as stored in each
data file. Data for these parameters is averaged over the sample time for
each sample.
Velocity/Temperature/Relative Humidity Probe
Velocity/Temperature Probe
960 (Straight)
962 (Articulated)
USB A
This standard USB connector is provided for use with “flash drive”
devices to download data from the instrument and transfer to a computer
or other device. The data files are in XML format for easy use in
spreadsheet programs. You can plug in a flash drive at any time. Make
sure there is enough space free on the drive to download data files. See
instructions on using the flash drive in Chapter 4.
A keyboard can also be used with this standard USB connector, to
facilitate data entry at the portable, if desired, as an alternative to the
touch screen keyboard.
To Next Page
Loading...
Need help?
General
