Chapter 3
30
Manual Mode
Log Interval
The log interval can be set from 1 second
to 60 minutes. It is the amount of time
between logged data points.
Test Length
Test length can be set from 1 minute to the
limit of the data storage.
Time Constant
Time Constant can be set from 1 to 60
seconds. This will control the update rate
of the main screen. It is the rolling average
of data displayed on the main screen and is
not linked to logged data in either Manual
or Program Log modes.
In Manual mode, data will be stored to a file named “Manual_XYZ” where
XYZ is an incrementing integer.
To Next Page
Loading...
Need help?
General
