Maintenance
9U-Line Service
Maintenance
Leveling
Unit must be level, for proper door and ice maker (if
equipped) operation.
For Models with adjustable leveling feet:
1. Use a level to check the levelness of the unit from front to back
and from side to side. Place the level along top edge and side edge
as shown (1).
2. If the unit is not level, rotate the adjustable leveling legs to raise or
l
ower each corner of the unit as necessary.
3. Check levelness after each adjustment and repeat the previous
s
teps until the unit is level.
For Models without adjustable leveling feet:
The unit must be located on a level surface, for proper door
and ice maker (if equipped) operation.
Use a level to check the levelness of the unit from front to back
and from side to side. Place the level along top edge and side edge
as shown (1).
Removing and Installing Grille
WARNING
!
Disconnect electric power to the unit before removing
the grille.
CAUTION
!
DO NOT touch the condenser fins(4). The condenser fins
are SHARP and can be easily damaged.
1. If endcaps were included, ensure they are installed on grille.
2. For some 75 series product you must tilt the grille into place,
hooking the back first.
3. Align and install screws.
4. Install knob.
5. Re-connect power.
1
5
6