3. Power on the drone and put it on a flat surface in a horizontal position. The
drone body lights change from flashing to solid bright, which indicates
successful frequency pairing.
Flying Control
4. Do not move the Left Stick before successful
calibration. Push the Right Stick as Picture 19
and then release. The drone body lights flash,
which indicates that the drone is calibrating.
When the drone body lights remain solid, which
indicates successful calibration.
Notice: Fail to calibrate may cause loss of drone function.
Push the Left Stick up to fly the drone up,
and pull the Left Stick down to fly the
drone down.
Move the Right Stick to the left to fly the drone
to the left, and move the Right Stick to the right
to fly the drone to the right.
1. To fly to the left or right 2. To fly up or down
4. To fly forward or backward3. To rotate to the left
Move the Left Stick to the left to rotate the
drone to the left, and move the Left Stick to
the right to rotate the drone to the right.
5. If the drone rotates to the left or right
Press the Right Rudder Trimmer till balance if the
drone rotates to the left, and press the Left
Rudder Trimmer till balance if the the drone
rotates to the right.
6. If the drone tilts forward or backward
Press the Backward Trimmer till balance if the
drone drifts forward, and press the Forward
Trimmer if the drone drifts backward.
Push the Right Stick up to fly the drone
forward, and pull the Right Stick down to
fly the drone backward.
Forward Backward
Rotate left Rotate Right
Tilt forward Tilt backward
Picture 19
11