Low Battery Alarm
When the drone in low battery, the transmitter will beep constantly to remind the
user to land the drone as soon as possible. The flip function will turn off
automatically when the drone in low battery.
Out of Range Alarm
When the drone flying out of the max remote control distance, the transmitter will
beep to alarm the user to fly back the drone immediately. Or the drone may out of
control and fly away.
Propellers Stuck Protection
1. When the drone propeller was stuck, the drone body lights flash rapidly and the
propellers stuck protection function turn on automatically. The motor will stop.
2. Move the left stick to the lowest end to turn off propellers stuck protection
function. The drone body lights get solid bright and the drone is ready to fly.
Propeller Installation Diagram
1. Insert the spanner between the motor
and the propeller as Picture 25, then
press down the spanner as Picture 26
to remove the propeller.
Picture 25 Picture 26
To turn on Heading Hold Mode, press Heading Hold Mode
button and the drone LED lights flash, which indicates the drone
enters heading hold mode.
To turn off Heading Hold Mode, press Heading Hold Mode
button again and the drone LED lights turn solid, which
indicates the heading hold mode is off.
Prerequisite: Position the drone in such a way that its front is your front (see Picture 1).
Tip: Do not change the orientation of the transmitter (see Picture 2) after entering heading hold mode.
Picture 1
Picture 2
Front
(Green Light)
Rear
Left Right
Front
(Green Light)
Rear
Left Right
14
To Next Page
Loading...
Need help?
General
