Charging Instruction
1. Connect the drone battery with USB plug first and then choose one of the
method as below picture shown to connect with USB plug. (prior to choose
2A, 5V charger)
2. The red USB indicator light keeps bright when charging. The light turns green
when fully charged.
* Do not put the battery on high temperature place, such as fire or heating device
to avoid damage or explode.
4. Li-Po battery is included in spare parts and please pay attention on the safe notice.
3. If do not fly the drone more than one week, maintain the drone battery with
about 50% power to keep its performance and working life.
* Do not use the battery to crash or hit hard surface.
* Do not put the battery in water and keep it in dry place.
* Do not open the battery.
* Do not leave the battery without supervision when charging.
* Make sure that there is no short circuit of the power wire.
* Please use the recommended charger only.
* Check the charger’s wire, plug, surface regularly. Do not use any broken charger.
* When the drone in low battery, the transmitter will beep constantly and the drone
body lights will change from flashing to solid bright to remind the user to land
the drone as soon as possible. Or the drone may fall down suddenly.
* When the transmitter in low batteries, the transmitter will beep constantly to
remind the user to land the drone as soon as possible and replace new batteries.
Or the drone may out of control.
Drone Battery
Li-Po Battery Disposal & Recycling
Wasted Lithium-Polymer batteries must not be placed with household trash.
Please contact local environmental or waste agency or the supplier of your
model or your nearest Li-Po battery recycling center.
5
To Next Page
Loading...
Need help?
General
