7. If the drone tilts to the left or right
Press the Right Trimmer till balance if the drone
drifts to the left, and press the Left Trimmer till
balance if the drone drifts to the right.
Drift left Drift right
Two Take Off Methods
Two Landing Methods
Altitude Hold Mode
Take Off / Landing /
Emergency Stop Button
Functions Introduction
2. Method 2 (One Button Take Off): Press the Take Off /
Landing / Emergency Stop Button (Picture 21) , the
drone will fly up automatically and keep flying at an
altitude of 1.2 meters approximately.
1. Method 1 (Take off): Push the Left Stick and Right
Stick as Picture 16 shown to start the motor and
then release. Then push up the Left Stick to fly up
the drone to certain altitude and then release the stick.
Picture 20
▲Emergency Stop: When the drone in emergency situation and going to hit the
walking people or obstacle etc., press the Take Off / Landing / Emergency Stop
Button immediately and hold it for more than 1s. The propellers will stop
immediately.
Tip: Do not use the emergency stop function unless in emergency situation.
The drone will fall down suddenly after all propellers stop.
1. Method 1 (Landing): Push the Left Stick all the way down to the lowest position
and hold it till the motors stop and the drone landing on the ground.
2. Method 2 (One Button Landing): Press the Take Off / Landing / Emergency Stop
Button once shortly, and the drone will land on the ground automatically.
Altitude hold mode indicates that the drone maintains a
consistent altitude while allowing roll, pitch, and yaw to
be controlled normally. It makes it easier to control the
drone for beginner and more stable for aerial photography.
Push the Left Stick up (down) to fly the drone up (down)
at certain altitude and then release the Stick. The Stick will
back to the center position (Altitude Hold Center) as the shown in Picture 21.
And the drone will keep flying at current altitude. Repeat above steps if you want
to change the drone altitude.
Altitude Hold Center
Picture 21
12