Measurement Operation (6)
l The LCD displays
indicating open-circuit for the
tested resistor or the resistor value is higher than
the maximum range of the Meter.
l When resistance measurement has been completed,
disconnect the connection between the testing leads
and the circuit under test.
Conductance Measurement (see figure 8)
(figure 8)
Select
nS Test
blackred
The resistance ranges from 0.01nS to 80nS. To measure
conductance, connect the Meter as follows:
1. Insert the red test lead into the
V Hz terminal
and the black test lead into the COM terminal.
2. Set the rotary switch to
and press RANGE
to select nS measurement mode.
3. Connect the test leads across with the object being
measured.
The measured value shows on the display.
Note
l It is possible to press HOLD to toggle between
conductance and resistance value during the
measurement of conductance.
l When conductance measurement has been completed,
disconnect the connection between the testing leads
and the circuit under test.
Model UT70C: OPERATING MANUAL
21
To Next Page
Loading...
Need help?
General
