UTD1000 User Manual
ĸ
You have to set the probe attenuation factor of the
Oscilloscope. This factor changes the vertical range
multiple to ensure the measurement result correctly
reflects the amplitude of the signal being tested. Set the
attenuation factor of the probe as follows : Select other
menu in Channel A then set probe ratio to 10X with the
jog dial.
Figure 1-4 Adjusting the probe ratio
Ĺ
Connect the probe tip and ground clamp to the
output terminal of the function signal generator. Select
a square wave of 1kHz output frequency and 3Vpp
amplitude. Press [AUTO] and you will see a 1kHZ/3Vpp
square wave in the display in a few seconds, as shown
in Figure 1-5. Repeat steps 2 and 3 to check Channel B.
Figure 1-5 Square wave signal 10:1
To Next Page
Loading...
Need help?
General
