UTD1000 User Manual
ķ
Connect the probe of the digital storage Oscilloscope
to the red input terminal (Channel A), and set the
attenuation switch of the probe to 10X.
Figure 1-3 Setting the probe attenuation switch
office.
In the event of any shipping damages, please retain the
packaging and notify our shipping department or your
Uni-T dealer. We will be glad to arrange maintenance or
repair
3. Functional Check
Carry out a quick functional check in the following steps
to make sure your Oscilloscope is operating normally.
1. Power on the unit
Power on the unit. You can select from two power
supply methods : internal battery power or external DC
adaptor power. Power supply voltage of the DC adaptor
is grid voltage. After connecting to power, start the self
calibration process by pressing the [USER] button then
[F3]. This will ensure optimal performance.
2. Accessing signals
Your UTD1000 Oscilloscope has dual input channels.
Please access signals in the following steps :
To Next Page
Loading...
Need help?
General
