UTD1000 User Manual
5. Automatic Setups
Automatic Setup for Waveform Display
Your UTD1000 Oscilloscope features an auto setup
function. It can automatically adjust the vertical
deflection factor, scanning time base and trigger mode
based on the input signal, until the most appropriate
waveform is displayed. The automatic setup function
can only be operated when the signal to be measured is
50Hz or above and the duty ratio is larger than 1%.
Using the Automatic Setup Function :
1.Connect the signal to be tested to the signal input
channel.
2.Press [AUTO]. The Oscilloscope will automatically set
the vertical deflection factor, scanning time base and
trigger mode. Should you require to make more detailed
check, you can adjust manually after the automatic
setup process until you get the optimal waveform
display.
6. Getting to Know the Operation Panel
Please see Figure 1-7 below for operation front panel
instructions :
Figure 1-7 Operation front panel
To Next Page
Loading...
Need help?
General
