UNI-T UTD1202C User Manual


UTD1000 User Manual
The Trigger System :
Press [TRIGGER] to adjust the trigger setup of the
waveform. For the trigger menu, see Figure 1-8.
Figure 1-8 Trigger System Setup
The above operation steps are detailed in the next
chapter.
The Vertical System :
By press the key to adjust the vertical range (V/div)
of the Oscilloscope, you can adjust the signal to a size
best suited to screen display.
By press the key to adjust the position of the
reference waveform reference point, you can adjust the
signal to the position best suited to screen display.
The Horizontal System :
Press the (s, ns) key to change the horizontal
time base range setup. Range of horizontal scanning
rate is 5ns-50s/div (UTD1102C) in steps of 1-2-5.
Note : Minimum horizontal time base range of the
UTD1000 Series varies from model to model.
Press the key to adjust the horizontal position
of the trigger point. You can observe more pre-trigger
information.


UNI-T UTD1202C Specifications

General

Brand	UNI-T
Model	UTD1202C
Category	Test Equipment
Language	English