UGP 10
24
7.0 ALARM SIGNALS
7.1. NORMAL OPERATION: RED L.E.D. flashes once every 30 seconds,
indicating that the alarm is powered
7.2 ALARM CONDITION: Repeating signal pattern: RED LED turns
"on" for 2 seconds with 4 short beeps and then 5 seconds of silence.
Pushing and holding the test/reset button for 3 seconds will silence the
alarm for about 4 minutes. After 4 minutes, the alarm will once again
sound until the unsafe CO concentration is reduced.
7.3. TROUBLE/SERVICE CONDITION: The alarm self-tests every 10
minutes. The alarm will beep and the RED LED flashes once every 30
seconds if a fault is detected. This is an indication of a malfunction and that
the detector requires immediate servicing or replaced
7.4. LOW BATTERY: RED LED flashes and horn chirp every 30 seconds.
Replace battery when this signal occurs
8.0 MAINTENANCE CLEANING YOUR ALARM:
8.1. Keep your CO alarms clean – use a damp (water only) cloth or vacuum.
8.2. To clean your alarm, remove it from the mounting bracket as outlined in
Figure 2 Step D: Installation/Removal. IF TAMPER RESISTANT PIN
HAS BEEN USED, REFER TO STEP 6.7 UNDER INSTALLATION
INSTRUCTIONS FOR REMOVAL INSTRUCTIONS. (See Figure 3)
8.3 You can clean the interior of your alarm by using your vacuum cleaner
hose and vacuuming through the openings around the perimeter of the
alarm.
8.4 The outside can be wiped with a cloth.
8.5 After cleaning, reinstall your alarm and test your alarm by using the TEST
button.
8.6 Test your detectors weekly and repair or replace them when they no
longer function. As with any electronic product, alarms have a limited life
and alarms that do not work cannot protect you. (See section 10.0)
WARNING: Do not use any household cleaning agents, paints, varnishes
or any other chemical on your COSTAR 9RV-SSO alarm.
To Next Page
Loading...
Need help?
General
