Chapter 3
Barcode Setting
The scanner interface can be configured to fit the user's specific application. All
configuration parameters are stored in a non-volatile memory, which is retained
even if power is lost.
Barcode Menu Setting
The setup menu in Appendix D contains eight groups:
* Group 1: Device selection.
* Group 2: Beep and delay.
* Group 3: Keyboard and Wand Emulation.
* Group 4: RS-232 Settings
* Group 5: Scanner port.
* Group 6: Magnetic Reader
* Group 7: Code 39, I 2 of 5, S 2 of 5 and Code 32.
* Group 8: Code 128, Code 93, Code 11, Codabar, and MSI.
* Group 9: UPC/EAN, and Delta Distance Code.
* Group 10: Data Editing.
* Group 11: Dump setup.
Setup Procedures
For most parameters, proceed the following steps for the setting:
1. Locate a group that contains the parameter to be changed.
2. Scan the "Enter Group #" label to enter setup mode. The green LED on the
scanner will flash to indicate that setup is in progress.
3. Scan the label (on right hand side) representing the parameter to be changed,
such as B1 label.
4. Scan the labels (number) representing the desired parameter value; for
example, for 05, scan “0” and “5” labels.
5. Repeat steps 3 and 4, if necessary, to change the parameters in the same
group.
6. Scan "Exit" label to end the group setup. The scanner will make two beeps to
end the setup.
21
To Next Page
Loading...
Need help?
General
