Unitech PA692 User Manual

- 7 -
Turning ON the PA692 for the First Time
After you have initially charged your device for about 16 hours, the device is
ready to be used. You can now start up your device. You can then calibrate the
display, learn some basic stylus usage, and set up the system time zone, date
and time.
Power-On Button
Turn ON your device by pressing the power button on the front panel.
Installing the Battery
WARNING! Thereisariskofreandburnsifthebatterypackishandled
improperly. DO NOT disassemble, crush, puncture, short external
contacts,ordisposethebatterypackinreorwater.DONOT
attempt to open or service the battery pack. Dispose of used
batteries according to local recycling guidelines in your area.
A backup battery cell is embedded into your device to prevent data loss when
the main battery pack is removed or completely discharged. This backup
battery will keep the data and system setting for up to 2 hours if the main
battery is removed.
NOTE: To enable the backup battery cell to provide backup power supply,
charge your device with the main battery pack for at least 16 hours.
NOTE: To power on the device properly, make sure to replace the battery
compartment cover after installing the battery.
1. Open the battery compartment
cover by sliding the tabs on both
sides in the direction of the arrows
shown and lift the cover up.
Battery Compartment
Tab

Unitech PA692 Specifications

General

Touchscreen	-
Display diagonal	3.7 \
Display resolution	800 x 480 pixels
ROM capacity	512 MB
Internal memory	0.512 GB
Internal memory type	DDR
Compatible memory cards	MicroSD (TransFlash)
Built-in processor	Yes
Processor frequency	1 GHz
Processor manufacturer	Texas Instruments
Operating system installed	Android
Wi-Fi standards	802.11a, 802.11b, 802.11g
Bluetooth version	2.1+EDR
Certification	CE, FCC, BSMI, VCCI, CCC, RoHS
Product color	Black
Keyboard layout	Alphanumeric
Linear (1D) barcodes supported	Code 11, Code 128, Code 128A, Code 128B, Code 128C, Code 32, Code 39, Interleaved 2 of 5
International Protection (IP) code	IP65
2D (matrix & stacked) barcodes supported	Aztec Code, Composite Codes, MaxiCode, Micro QR Code, MicroPDF417, PDF417, QR Code, Small Aztec Code, TLC-39
Rear camera resolution (numeric)	5 MP
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	-20 - 60 °C
Operating relative humidity (H-H)	5 - 95 %
Headphone outputs	1
Headphone connectivity	3.5 mm
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.

Weight and Dimensions

Depth	74 mm
Width	177 mm
Height	40 mm
Weight	- g