Unitech PA692 User Manual

- V -
Battery Notices
The PA692 is equipped with a Lithium-Ion battery pack and a Ni-Mh backup
battery. Both batteries will discharge after an extended period of no use.
When both batteries are discharged, recharge the unit for 12 hours in order to
fully charge the main battery and backup battery. Recharge the PA692 battery
by doing the following:
1. Plug the USB charging cable into the PA692 and plug the 5V/3A AC-DC
adapter into the power jack of the USB charging cable.
2. Place the PA692 into the docking station and plug the 5V/3A AC-DC adapter
into the power jack of the docking station.
If the main battery is removed, the backup battery ensures the data on
SDRAM is safe for up to 2 hours. To prevent data loss, do not leave the PA692
uncharged with the main battery removed for an extended period. See the
Charging the Battery unit on for more details.
NOTE: To guarantee optimal performance, it is advised that rechargeable
batteries be replaced every year, or when 500 charge/discharge cycles
are achieved. It is normal that the battery balloons or expands beyond
one year or the maximum of 500 cycles. Although it does not cause
harm, it cannot be used again and must be disposed of according to
the location's safe battery disposal procedures.
If the performance decrease is greater than 20% in a Lithium-Ion
battery, the battery is at the end of its life cycle. Do not continue to use,
and ensure the battery is disposed of properly.
The length of time that a battery lasts depends on the battery type and how the
device is used. Conserve the battery life by doing the following:
•
Avoid frequent full discharges because this places additional strain on the
battery. Several partial discharges with frequent recharges are better than
a full discharge. Recharging a partially charged lithium-Ion battery does not
cause harm because there is no memory.
•
Keep the lithium-Ion battery cool. Avoid a hot car. For prolonged storage,
keep the battery at a 40% charge level.

Unitech PA692 Specifications

General

Touchscreen	-
Display diagonal	3.7 \
Display resolution	800 x 480 pixels
ROM capacity	512 MB
Internal memory	0.512 GB
Internal memory type	DDR
Compatible memory cards	MicroSD (TransFlash)
Built-in processor	Yes
Processor frequency	1 GHz
Processor manufacturer	Texas Instruments
Operating system installed	Android
Wi-Fi standards	802.11a, 802.11b, 802.11g
Bluetooth version	2.1+EDR
Certification	CE, FCC, BSMI, VCCI, CCC, RoHS
Product color	Black
Keyboard layout	Alphanumeric
Linear (1D) barcodes supported	Code 11, Code 128, Code 128A, Code 128B, Code 128C, Code 32, Code 39, Interleaved 2 of 5
International Protection (IP) code	IP65
2D (matrix & stacked) barcodes supported	Aztec Code, Composite Codes, MaxiCode, Micro QR Code, MicroPDF417, PDF417, QR Code, Small Aztec Code, TLC-39
Rear camera resolution (numeric)	5 MP
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	-20 - 60 °C
Operating relative humidity (H-H)	5 - 95 %
Headphone outputs	1
Headphone connectivity	3.5 mm
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.

Weight and Dimensions

Depth	74 mm
Width	177 mm
Height	40 mm
Weight	- g