Unitech PA692 User Manual

- II -
Regulatory Compliance Statements
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference with radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference with radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
1. This Transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth
for an uncontrolled environment. To maintain compliance with FCC RF
exposure requirements, avoid direct contact to the transmitting antenna
during transmitting.
3. Anychangesormodications(includingtheantennas)madetothisdevice
that are not expressly approved by the manufacturer may void the user’s
authority to operate the equipment.
Operation on the 5.15 - 5.25GHz frequency band is restricted to indoor use
only. The FCC requires indoor use for the 5.15-5.25GHz band to reduce the
potential for harmful interference to co-channel Mobile Satellite Systems.
Therefore, it will only transmit on the 5.25-5.35 GHz, 5.47-5.725 GHz and 5.725
–5.850GHzbandwhenassociatedwithanaccesspoint(AP).

Unitech PA692 Specifications

General

Touchscreen	-
Display diagonal	3.7 \
Display resolution	800 x 480 pixels
ROM capacity	512 MB
Internal memory	0.512 GB
Internal memory type	DDR
Compatible memory cards	MicroSD (TransFlash)
Built-in processor	Yes
Processor frequency	1 GHz
Processor manufacturer	Texas Instruments
Operating system installed	Android
Wi-Fi standards	802.11a, 802.11b, 802.11g
Bluetooth version	2.1+EDR
Certification	CE, FCC, BSMI, VCCI, CCC, RoHS
Product color	Black
Keyboard layout	Alphanumeric
Linear (1D) barcodes supported	Code 11, Code 128, Code 128A, Code 128B, Code 128C, Code 32, Code 39, Interleaved 2 of 5
International Protection (IP) code	IP65
2D (matrix & stacked) barcodes supported	Aztec Code, Composite Codes, MaxiCode, Micro QR Code, MicroPDF417, PDF417, QR Code, Small Aztec Code, TLC-39
Rear camera resolution (numeric)	5 MP
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	-20 - 60 °C
Operating relative humidity (H-H)	5 - 95 %
Headphone outputs	1
Headphone connectivity	3.5 mm
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.

Weight and Dimensions

Depth	74 mm
Width	177 mm
Height	40 mm
Weight	- g