Uponor Smatrix Base PULSE User Manual

Uponor Smatrix Base T-141
3
3.1
3.2
4
1
2
SI0000206
4.2
4.1
Note
This operation might need two persons to complete.
To factory reset the thermostat:
1. Remove the thermostat from the wall.
2. Disconnect the controller from the power supply.
3. Press and hold the registration button on the thermostat while
reconnecting the controller to power again.
4. Release the button after about 10 seconds when the LED start
flashing.
5. The thermostat is now reset to factory default.
Uponor Smatrix Base T-143
3
4
1
2
SI0000194
To factory reset the thermostat:
1. Angle the thermostat from the bracket.
2. Remove it from the wall.
3. Gently press and hold the registration button on the thermostat,
release when the demand LED starts flashing.
4. Change the Disable timer switch twice, regardless of starting
position.
5. The thermostat is now reset to factory default.
Uponor Smatrix Base T-165
3
4
1
2
SI0000195
To factory reset the thermostat:
1. Angle the thermostat from the bracket.
2. Remove it from the wall.
3. Gently press and hold the registration button on the thermostat,
release when the demand LED starts flashing.
4. Change the Disable timer switch twice, regardless of starting
position.
5. The thermostat is now reset to factory default.
Uponor Smatrix Base T-146/T-148
5 s
SI0000196
To factory reset the thermostat:
1. Press and hold the -, + and OK buttons for about 5 seconds until
the screen goes blank.
2. The thermostat is now reset to factory default.
Uponor Smatrix Base T-149
5 s
SI0000197
To factory reset the thermostat:
1. Press and hold the
, and OK buttons for about 5 seconds
until the screen goes blank.
2. The thermostat is now reset to factory default.
Uponor Smatrix Base PULSE
|
Installation and operation manual
|
81

Uponor Smatrix Base PULSE Specifications

General

Brand	Uponor
Model	Smatrix Base PULSE
Category	Controller
Language	English