USR-N580 User Manual technical support:h.usriot.com
Jinan USR IOT Technology Limited
26
www.usriot.com
4.4 UDP Client Mode
1. In UDP Client mode, N580 will only communicate with the destination IP and port.
2. It is usually used in data transmission scenarios where the packet loss rate is low, the packet is small and
the transmission frequency is fast, and the data should be transmitted to the specified IP.
3. Test example:
Set the N580 to UDP Client, Remote server address is the computer’s IP, set the Remote Port to 8234.
Click Save then Restart the device.