2PS/2PT-1
1-5-29
(3) Detaching and refitting the main PWB
Procedure
1. Remove the SSD* or network interface
card, if installed.
*: 26/28 ppm model only
2. Remove the IF cover (see page 1-5-3).
3. Remove two pins and then remove the
SSD or network interface card.
Figure 1-5-41
4. Remove the top cover (see page 1-5-3).
5. Remove the right rear cover, right cover
and right lower cover (see page 1-5-5).
6. Remove four screws and then remove
the power source shield.
Screws A and B are unidentical, there-
fore, do not mix up.
Figure 1-5-42
Power source shield
Screw B
Screws
Screw A
To Next Page
Loading...
Need help?
General
