2PS/2PT-2
2-4-9
(4) Maintenance Commands
This section provides information on how to use the maintenance command and its parameters using exam-
ples.
Coverage setting
Description
Make settings on the color print coverage counter displays, as well as the coverage threshold.
Purpose
Make settings on the color print coverage counter displays.
Example 1: Set the coverage counter.
!R! KCFG “TCCM”,1;EXIT;
Purpose
Setting the coverage thresholds to segment the color count depending on the density level of 1, 2, and 3, for
the counters of color printing.
Example 1: Set the low coverage to 2%.
!R! KCFG “STCT”,1,20; EXIT;
Example 2: Set the middle coverage to 5%.
!R! KCFG “STCT”,2,50; EXIT;
* : All prints at or above the Level 2 set percentage will be counted as Level 3, High Coverage.
Format
!R! KCFG “TCCM”,#;EXIT;
Parameter
The counter of full color printing is divided into three steps by the average coverage of
the toner of "Y. M.C."
0 = (Only One Step) Full Color Counter : Initial Value
1 = Color Coverage Counter
Format
!R! KCFG “STCT”,#,#; EXIT;
Parameter Level 1
(Low Coverage)
!R! KCFG “STCT”,1,#; EXIT;
(The Level 1 value # can be set from 1 to 999, in 0.1%
increments)
All prints with Level 1 set percentage of coverage or less will be
counted as Low Coverage.
Level 2
(Middle Coverage)
!R! KCFG “STCT”,2,#; EXIT;
(The Level 2 value # can be set from 2 to 999, in 0.1%
increments)
All prints above the Level1 percentage and Level 2 set
percentage or less will be counted as Middle Coverage.
To Next Page
Loading...
Need help?
General
