To Next Page

To Previous Page

ENGLISH

6 - ACCESSING THE CONTROL

UNIT SETTINGS

1. Press and hold the OK key until the display shows the menu

desired

2. Release the OK key: the display will show the first item in the

sub-menu

-PrG Programming the control unit (Chapter 11)

-C nt Cycle counter (Chapter 10)

-SEt Installation menu (Chapter 8)

-dEF Loading the default parameters (Chapter 7)

m WARNING: in case no operation is carried out for

more than one minute, the control unit exits from the

programming mode without saving any of your setups and

changes, which will get lost.

7 - LOADING THE DEFAULT

PARAMETERS (dEF)

If necessary, it is possible to restore all parameters to their

standard or default values (see the final summary table).

m PLEASE NOTE: This procedure results in the loss of all

customised parameters.

1. Press and hold the OK key until the display shows

-dEF

2. Release the OK key: the display shows ESC (only press the

OK key if it is desired to exit this menu)

3. Press the

key: the display shows dEF

4. Press the OK key: the display shows no

5. Press the

key: the display shows Si

6. Press the OK key: all parameters are overwritten with their

default values (see Chapter 11), the control units exits

programming mode and the display shows the control panel.

V2 ALFARISS User Manual

Questions and Answers: