To Next Page

To Previous Page

ENGLISH

9 - EMERGENCY MAN PRESENT OPERATION

This operational mode can be used to move the gate in Man Present mode in particular cases, such as installation/maintenance or in the

case of malfunctioning of photocell, edge, limit switches or encoder.

To start the “emergency” dead man operating mode activate the start command (START) for 3 seconds.

Note: if the

Strt parameter is set as StA n, the Start command (from the terminal block or remote control) moves the gate in the

open and closed directions alternatively (unlike the normal Man Present mode).

Emergency man present mode ends after 10 seconds of the gate not moving.

Example

Questions and Answers:

Need help?

Do you have a question about the V2 ALFARISS and is the answer not in the manual?

V2 ALFARISS Specifications

General