Val Controls IHP24-F User Manual

DID-UM-002
Val Controls A/S • Limfjordsvej 3 • DK-6715 Esbjerg N • Tel. +45 7547 0600
vc@valcontrols.com • www.valcontrols.com
Revision: 10
11/74
5 Configuration - ValConnect
All configuration of the IDC must be done through a USB connection to a computer with
ValConnect installed. ValConnect can be downloaded at www.valcontrols.com.
Disable PST, FST or SOT
PST, FST and SOT can be disabled, so that reference tests are not run during the autocalibration.
This can be archived by setting all DO to “Not used” in valve configuration under each
corresponding section in ValConnect.

Val Controls IHP24-F Specifications

General

Brand	Val Controls
Model	IHP24-F
Category	Controller
Language	English