Adjust Sensitibity
1.
OX
is default as displayed on screen. When selected LOC, the sensitivity will
decrease
of
20dB.
You
can select LOC when operating SEEK near
broadcasting station.
2.
Press LOC/OX at downside
in
dispay to change the sensibility.
Stereo Broadcast (ST)
When ST appears at upside
of
display, it's stereophonic broadcasting. If not, it's
monophonic broadcasting.
Using Preset Stations
Ten
stations are preset and recall stations for each band.
All ten stored stations for the current band appear on the
TFT screen.
.Storing Stations
1.
Select a band(if needed), then select a station.
2.
Press to hold
1-0
buttons
in
remote control or
1-10
of
station list at leftside
in
display (Press T at leftside
of
the list, if needed) for 3 seconds to store
each station's frequency to the number.
3.
To
listen to a corresponding stored station, press
1-0
buttons
in
remote
control or
1-10
in
display.
Auto Store (AS)
Use Auto Store function to select six strong stations and store them automatically
in
current band.
1.
Select a band (if needed).
2.
To
activate Auto Store function, press AS/PS at downside
in
display for 3
seconds. The new stations replace the stations already stored
in
that band.
Preset Scan (PS)
Scan stored stations
in
the current band.
1.
Select a band (if needed).
2.
Press AS/PS
in
display, the unit pauses for 3 seconds at each preset station.
3.
Press AS/PS again to stop scanning when a desired station
is
found.
18
To Next Page
Loading...
Need help?
General