DRIVING MODES
AUTOMATIC MODE
When you start the tractor the automatic driving mode is automatically selected.
There are two main ways of driving:
• Pedal driving (no symbol on displays)
• Lever driving (symbol on displays)
You can control the driving speed with the drive pedal or the drive lever. The
transmission ratio is controlled automatically. Speed range changes (ABCD)
can be done with the +/- buttons on the lever.
DRIVING WITH DRIVE LEVER
When controlling speed with the lever, the symbol shows on the A-pillar display.
Start driving: When direction has been selected, the tractor doesn´t move.
To move push lever forward. Whenever you use the lever, you are in lever driving.
To go back to pedal control, tap the drive lever left.
Small movement of the lever changes the speed precisely.
Longer movement changes the speed faster.
Drive lever speed is visible in the driving display.
MANUAL MODE
Manual mode can be selected with push button
on armrest.
When the manual mode is engaged, the symbol M for the manual
driving mode shows on the A-pillar display and the SmartTouch display.
(Manual can be engaged on work areas A and B only).
Start driving: When the direction has been selected, the tractor doesn´t move.
To move choose transmission ratio with the lever.
Control the engine speed with the drive pedal or the hand throttle.
If you changed to Manual while tractor is moving, the transmission ratio used will be
maintained until you change it. You can also store a certain transmission ratio into
memory by keeping the drive lever right 1 second. So instead of speed cruise, there is
a transmission ratio memory. Tapping driver lever left recalls ratio zero.
11
T/N Series Quick Guide / Direct
To Next Page
Loading...
Need help?
General
