PTO
You can use the power take-off (PTO) to transmit
power from the tractor to an implement.
1.
Start the engine and tap the PTO symbol on the SmartTouch
screen to open the PTO settings.
2.
Select the PTO speed. The value stays even in memory when
you turn the ignition off.
3.
Adjust the setting for the PTO start aggressiveness if needed.
Higher value gives you a shorter engagement time.
4.
You can control the start and stop of the PTO with the switches
on the armrest.
Push the switch down and pull it back to start the PTO.
To stop the PTO, push the PTO switch down and forward.
TIP: You can program PTO start and stop to M1, M2 or M3 buttons
as single operation or as a part of headland management
(U-Pilot) sequence.
PTO Cruise: when activated you can get correct PTO speed
automatically with press of engine speed memory button,
see next page.
1
2
3
4
T/N Series Quick Guide / Direct
28
To Next Page
Loading...
Need help?
General
