5.9 Check if user has no card assigned
Enter programming mode, then press:
Step Keypad
Entry
Operation
1 81 Check if user has no card already assigned
2 000 –
127
User 0 – 127
Keypad will flash the green LED and sound high-pitched tone if the user has NO card assigned.
The keypad will flash the red LED and sound low-pitched tone if the user has a card.
5.10 Program ACT 5e prox options
Enter programming mode, then press:
Step Keypad Entry Operation
1 30, 31, 32, 40 or 41 2 digit option number
2 0 or 1 0=Off, 1= On
Options are as follows:
Option Function Default Operation
30 Card or PIN On When set, a valid Card or valid PIN will open the door.
31 Card and
PIN
Off When set, only users with both a Card and PIN are admitted. Cards are assigned
to a particular user using the Adding Cards function (function 5) and PINs are
assigned using the Changing PIN Codes function (function 0).
32 Card and
any PIN
Off In this mode, a valid card and any valid PIN code will open the door. This mode
allows all users to have a common PIN code to use with their cards.
40 Permanent
Backlight
On When set, the keypad illumination is always on. This option will override option
41 (Auto Backlighting).
41 Auto
Backlighting
Off When set, the keypad illumination is normally off, but will switch on in response
to any key being pressed, or when a card is presented or while in programming
mode. This option is overridden by option 40 (Permanent Backlight). To prevent
any illumination, turn off options 40 and 41.
5.11 Restore factory defaults
Enter the programming code followed by . This restores the ACT 5e prox to its default settings.
If the programming code has been forgotten, set it to 9999 as follows:
1. Remove the power from the unit.
2. Remove link LK1 at the back of the unit.
3. Apply power to unit.
4. Replace link LK1.
5. Programming code is now set to 9999.
ACT 5e prox – Installation and Operating Instructions ACT 5e prox Digital Keypad Programming
© Vanderbilt 2019 11 A-100512-e
25.06.2019
To Next Page
Loading...
Need help?
General
