EasyManuals Logo
Home>Vax>Vacuum Cleaner>ONEPWR Spotless Go CLCW-MSKS

Vax ONEPWR Spotless Go CLCW-MSKS User Manual

Vax ONEPWR Spotless Go CLCW-MSKS
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7
support.vax.co.uk
GETTING STARTED
Lift to remove the water/solution tank
from the side of the machine.
Press the on/off button to switch the
washer on.
Unscrew the cap and fill to the water
and solution markers on the tank.
Replace the cap and push the tank
down on to the machine until it clicks
into place.
IMPORTANT: Before using the machine to clean dried-on stains and dirt, the ooring should be
vacuumed throughly.
Test for colourfastness - Wet a white absorbent cloth with the solution. In a small hidden area of
your carpet/rugs/upholstery/hard oors, gently rub with the dampened cloth. Wait ten minutes
and check for colour removal or bleed with white paper towel or cloth. Check all carpets/rugs/
upholstery material before rst use and if your carpet has more than one colour, check all colours.
Test all carpets/rugs/upholstery/hard oors before use. Test the spot washer on a small hidden
area. If no damage or pile distortion occurs continue cleaning.
Move furniture out of the area to be cleaned. If the furniture cannot be moved, place aluminium
foil or wax paper under the legs. This will prevent wood nishes from staining your carpet.
Pin up furniture skirts and curtains.
When using the spot washer, basic safety precautions should always be observed and don’t over
saturate your carpets/rugs/upholstery/hard oors.
Only use VAX ONEPWR Multi-oor solution. Using other solutions may cause excess foaming and
will invalidate your guarantee.
The water/solution tank should only be lled with warm water (max 40⁰C). Filling the water/
solution tank with hot/boiling water will damage your washer and invalidate the guarantee.
IMPORTANT: Your dirty water tank is tted with a oat. When
the dirty water tank is full, the oat will shut o the suction on
the spot washer. You will be able to hear if this has happened as
the motor noise on the washer will increase. Once the oat is
activated, empty the dirty water tank if full.
If the dirty water tank is not full then turn o your washer at the
power switch and wait for the oat to settle.
OPERATION

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vax ONEPWR Spotless Go CLCW-MSKS and is the answer not in the manual?

Vax ONEPWR Spotless Go CLCW-MSKS Specifications

General IconGeneral
BrandVax
ModelONEPWR Spotless Go CLCW-MSKS
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals