Vector TCI-W11-U Series User Manual

TCI-W11-U, TCI-W22-U Universal Controller
TECHNICAL SPECIFICATION
Doc: 70-00-0140C, V2.0-20220523 © Vector Controls LLC, USA Page 4-24
Subject to alteration
Mounting Location
• Install the controller on an easy accessible interior wall, approx. 1.5 m above the floor in an area of average temperature.
• Avoid direct sunlight or other heat sources, e.g. the area above radiators and heat emitting equipment.
• Avoid locations behind doors, outside walls and below or above air discharge grills and diffusers.
• Location of mounting is less critical if external temperature sensors are used.
• Ensure adequate air circulation to dissipate heat generated during operation.
• Observe local regulations.
• Do not mount in a wet or condensation prone environments.
Installation instructions
See TCI-W installation sheet no. 70-000539 (www.vectorcontrols.com).
Dimensions mm (inch)

Vector TCI-W11-U Series Specifications

General

Brand	Vector
Model	TCI-W11-U Series
Category	Controller
Language	English