Installation Guide Safety Precautions
3
Use product with approved equipment: This product should be used only with Veeder-Root components
identified as suitable for use with the TLS RF Wireless System.
Use the correct external power sources: This product should be operated only from the type of power
sources indicated on the electrical ratings labels affixed to the components. If you are not sure of the type of
power source required, consult your Veeder-Root authorized service contractor.
SPECIAL TOOLS REQUIRED
• #15 Torx driver
• Small blade screwdriver (maximum blade width 3/32”)
• Wire strippers
Although not required for installation, a laptop computer, RS-232 serial communication cable (TLS RF has a
female DB9 connector) and terminal mode software may be necessary for troubleshooting.
SAFETY SYMBOLS
The following safety symbols are used throughout this manual to alert you to important safety hazards and
precautions:
EXPLOSIVE
Fuels and their vapors are extremely
explosive if ignited.
FLAMMABLE
Fuels and their vapors are extremely flammable.
ELECTRICITY
High voltage exists in, and is supplied
to, the device. A potential shock hazard
exists.
TURN POWER OFF
Live power to a device creates a potential shock
hazard. Turn Off power to the device and
associated accessories when servicing the unit
WARNING
Heed the adjacent instructions to avoid
equipment damage or personal injury.
READ ALL RELATED MANUALS
Knowledge of all related procedures before you
begin work is important. Read and understand all
manuals thoroughly. If you do not understand a
procedure, ask someone who does.
To Next Page
Loading...
Need help?
General
