12
HELPFUL HINTS
REPLACING THREAD SPOOLS
When replacing thread spools, the
following steps may be helpful for quick
changeover.
1. Cut off existing threads near the
spools. Tie the cut ends thread from
new spools as illustrated (seamen's
knot).
2. Raise presser foot.
3. Lower needle bar to its lowest
position by turning hand wheel away
from you. Carefully pull the existing
threads until the connecting knots
pass through needle eye and looper
eyes.
CUTTING NEEDLE THREAD
Frayed thread may make needle
threading difficult.
Draw the thread passing under the
thread cutter and turn hand wheel
towards you to obtain clear cut end as
illustrated.
3
1
2
To Next Page
Loading...
Need help?
General
