4
SETTING UP YOUR
MACHINE
1. Wipe off excess oil in the needle
plate and bed areas.
2. FOOT CONTROL
Push foot control plug into
connector socket, and connect
the power line plug into power
supply outlet.
3. POWER/LIGHT SWITCH
Your machine will not operate
unless the power/light switch is
turned on. This same switch
controls both machine power and
sewing light.
When leaving the machine
unattended, or servicing the
machine, remove the power line
plug from supply outlet.
4. OPENING FRONT COVER
To open front cover, pull it to the
right and down towards you.
5. OPENING WORKING TABLE
To open working table, pull the
release lever towards you with
your right hand, and lift the front
of presser foot up with your left
hand.
Release lever
Working table
Front cover
Connector
socket
Power/light switch
To Next Page
Loading...
Need help?
General
