14
7502026
f) General checks
Check all moving parts, the guards, labels and signs.
g) Guide cleaning
Make an accurate guide cleaning and waxing.
Annual checks:
a) Controls
Check their operation by trying out the stairlift in all func-
tions from on board (and from the control boards at the
floors if installed) in the working modes envisaged.
Make sure that the system has not been tampered with
or modified.
9.2) Problem - Possible causes - Possible remedies
Skill level: O - Trained operator
Problem Possible causes Possible remedies
The stairlift does not move Control enabling key Turn the key to ON
in either travel direction.
Emergency STOP pressed Turn the button clockwise through 45°
Differential security breaker Press the reset button. If it does not
tripped remain in the ON position, call in an
authorised VIMEC technician.
No power supply Check the power supply; see point 7.5
(operating by hand).
A safety device has been tripped Call in an authorised VIMEC technician
The stairlift moves downward Safety gear tripped Call in an authorised VIMEC technician
more quickly then cuts out
The stairlift does not move Overlimits safety device tripped Call in an authorised VIMEC technician
from either end of the stair
Control enabling key Turn the key to ON
The stairlift does not move in Check that there are no obstacles
one direction activating the safety devices
Fig. 5/c-d-e
The stairlift hits the stop Call in an authorised VIMEC technician
buffers
10) ELECTRICAL SYSTEM DIAGRAMS
The electrical system diagrams are in the folder supplied
with the lift
11) VIBRATIONS - AIRBORNE NOISE
a) Vibrations
The stairlift induces vibrations in the body and limbs of
the transported person having:
- low frequency and very low acceleration;
- short exposure times for the exposed person.
This parameter is therefore not significant for safety
purposes.
b) Airborne noise: less than 70 dBA.
12) INFORMATION ON DISPOSING OF PARTS OF
THE LIFT AND THE SUBSTANCES IT CONTAINS
a) Disposing of rubber and plastics
Place in clean containers and consign to disposal
centres authorised as required by the regulations in
force.
b) Oils and toxic materials
The lift does not contain oil or toxic materials.
b) Control panels at the floors
Check that the device is operating correctly.
c) Electrical system
Check that all electrical components, remote switches
and microswitches are operating correctly.
Check the conditions of the power cables inside the
cable carrier chain.
Check the continuity of the earth conductors.
Check that the earth conductors are connected to earth.
To Next Page
Loading...
General
