Visonic POWERMAXCOMPLETE User Manual

USER SETTINGS
30 D-302755
D. Present the tag to the control panel left bottom
side. In response, the “Happy Tune” (- - - –––) will
sound and the display will change to:
Tag No: 1
A dark box will appear at the far right, indicating that
the chosen tag has been enrolled.
E. Click
and enroll the next proximity
tag (2, 3,...8), as described in step D.
F. From this point on, you may continue in several
different directions:
• If you wish to enroll another tag, select the
desired number by:
- Clicking
to go up (678.....)
- Clicking
to go down (432.....)
- Clicking
 <tag#>.
• To return to the main menu, click
. This
will bring back the display:
<OK> TO EXIT
You may now review and select any other mode on
the User menu (by clicking
or ).
Deleting Proximity Tags
Proximity tag memory locations must be cleared
(enrolled ID must be deleted) before enrolling a new
ID. To delete an existing ID, proceed as follows:
A. Select the desired memory location, as described
in the previous paragraph, steps A-C. If, for
example, you selected Tag No. 5, the display will
read:
Tag No. 5
B. Click . The display will change to:
<OFF> TO DELETE
C. Click . The display will change to:
Tag No. 5
Note that the dark box at the far right has
disappeared. It is now possible to enroll a new ID. It
is also possible to leave the cleared zone or memory
location free and simply exit to the main menu.
Setting the Voice Options
(Not applicable in PowerMaxComplete that does not
have VOICE option)
Remember: Voice prompts are heard over the built-
in loudspeaker subject to two conditions:
- The voice option is enabled as shown below
- The loudspeaker is enabled by pressing the “7”
key (see Chapter 3 - Voice ON-OFF)
Here you may select one of two options:
Enable prompts: Voice announcements
Disable prompts: No voice announcements
The presently programmed option will be shown, with
a dark selection box (
) at the far right of the
display. You may view the other option (that does not
have a dark box at the far right) by clicking
. A dark box will appear if you click
while the other option is displayed.
To set the voice option, proceed as follows:
Having entered your Master User Code
successfully
(see above - Entering the User Settings Menu), click
the
button until the display reads:
SET VOICE OPTIONS
From here, proceed as follows:
PRESS
RESULTANT DISPLAY
enable prompts
(if this is the current option)
disable prompts
If not satisfied
disable prompts
If satisfied -
SET VOICE OPTION
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
. When <OK> TO EXIT is displayed - click
.
Note: When using the Model MCT-234 keyfob with the
PowerMaxComplete, the voice prompts must be
enabled.
Automatic Arming Option
You can determine that the system will be
automatically armed at any desired time.
Having entered master user code successfully, click
until AUTO ARM OPTION is
displayed.
From here, proceed as follows:
PRESS
RESULTANT DISPLAY
enable autoarm
(if this is the current option)
disable autoarm
If not satisfied
press
disable autoarm
AUTO ARM OPTION

Visonic POWERMAXCOMPLETE Specifications

General

Brand	Visonic
Model	POWERMAXCOMPLETE
Category	Security System
Language	English