43
Maintenance: Engine
Turning the engine
Insert the turning bar in the holes on the flywheel.
Turn the engine manually.
Warning! Make sure the turning bar is
removed before cranking the engine.
Vibration damper inspection
NOTE! When installing a damper protective
cover on the engine, do not use a cover
enclosing the damper.
Visually check for fluid leaks, flaws, distortion, or dis-
coloration or flaking of painted surfaces. Also check
for swelling (by measuring with a scale), and fluid le-
aks past staked portions.
Re-tighten bolts and nuts
Re-tighten the bolts and nuts on the following compo-
nents:
* Timing gear case
* Crankshaft pulley
* Mounting brackets
* Exhaust manifold
* Turbocharger
* Cylinder heads
Check the cylinder head bolts and re-tighten them in
number sequence (1-2-3-4-5-6-7-8) if necessary. The
tightening torques of the bolts and nuts can be found
in technical data section of this manual.
NOTE! In case retightening is necessary, first
unscrew the bolts completely.
Plus d'informations sur : www.dbmoteurs.fr
To Next Page
Loading...
Need help?
General
