36
Technical Data
General
Engine designation ....................................... AD31L/P D41L KAD42L/P
TMD31L AD41L/P KAMD42L/P
TAMD31L/M/P TMD41L TAMD42A/WJ*
TAMD41H/M/P
Idling speed, RPM ........................................ 675-725 625-725 625-675
Swept volume, dm³ ....................................... 2.39 3.59 3.59
cu.inch .................................. 145 216 219
Injection sequence ........................................ 1-3-4-2 1-5-3-6-2-4 1-5-3-6-2-4
Rotational direction,
seen from front ............................................. Clockwise Clockwise Clockwise
Max. forward tilt ............................................ 4° 4° 4°
Max. backward tilt when running .................. 15° 15° 15°
Max. side tilt when running ........................... 20° 20° 20°
Valve clearance, intake/exhaust, cold engine, mm .... 0.40 0.40 0.40
inch ... .0157 .0157 .0157
Engine, oil capacity, dm³, excl. oil filter ........ 8.5 10.5 10.5
quarts (US) .................. 8.0 9.9 9.9
Engine, oil capacity, dm³, incl. oil filter. ........ 9.0 11.0 11.0
quarts (US) .................. 8.5 10.4 10.4
At 15° backward tilt, dm³, excl oil filter ...... 9.0 11.0 11.0
quarts (US) ............... 8.5 10.4 10.4
At 15° backward tilt, incl. oil filter .............. 9.5 11.5 11.5
quarts (US) ............... 8.9 10.8 10.8
Oil type ......................................................... VDS or CD VDS or CD VDS or CD
Viscosity ....................................................... SAE 15W/40 SAE 15W/40 SAE 15W/40
Oil pressure, hot engine ...............................
Idling, kp/cm² ............................................. 1.5 1.5 1.5
psi ................................................... 21.3 21.3 21.3
WOT, kp/cm² ............................................. 4.2–5.0 4.2–5.0 4.2–5.0
psi ................................................... 59–71 59–71 59–71
Fuel specifications
The fuel must be approved according to national and international standards for commercial fuels, for ex-
ample:
– EN 590 (With environmental and sub-zero temperature specifications according to national requirements)
– ASTM D 975 No. 1-D and 2-D
– JIS KK 2204
Sulfur content: According to current legislation in the respective country.
Compressor **
Oil capacity, dm³ .......................................... 0.1
pints (US) ................................. .047
Oil type (Volvo Penta P/N) ............................ 1141592-4
Power Trim **
Oil capacity, dm³ ........................................... 1.0 1.0 1.0
quarts (US) ............................... .94 .94 .94
Oil type, viscosity ......................................... See engine See engine See engine
Oil type, DPX ................................................ ATF, type G
* TAMD 42A/WJ: For technical data on the water jet unit, refer to manufacturer’s manual.