Coolant Level, Checking and
Topping Up
WARNING!
Do not open the coolant filler cap when the engine is
hot, except in emergencies, as this could cause
serious personal injury. Steam or hot fluid could spray
out.
IMPORTANT!
Only use coolant recommended by Volvo Penta. Fill up
with the same type of coolant that is in the system.
Different types of coolant must not be mixed with each
other.
Filling of coolant must be performed with the engine
stopped. Fill up slowly, to allow the air to flow out.
Check the coolant level daily before start.
TWD16
1 Open the filler caps (1).
2 Check that the coolant reaches the MAX mark on
the sight glass (2). Top up with coolant as required.
3 Close the filler caps.
TAD16
1 Open only the filler cap (1). Do not open the
pressure cap (2).
2 Check that the coolant level is between the MIN and
MAX marks on the expansion tank (1). Top up with
coolant as required.
3 Close the filler cap.
TWD16
TAD16
Maintenance
78 47711296 01-2019 © AB VOLVO PENTA
To Next Page
Loading...
Need help?
General
