Parent unit settings
23
Pair/unpair CAM
Pair new CAM
The baby units and parent unit provided are already paired. You
can add or replace baby units (BM3110, purchased separately) to
your video and audio monitor system.
You can pair a maximum of four baby units to your parent unit.
Each new baby unit must be paired to the parent unit before use.
Make sure you power on the baby unit (see page 25) and the parent unit
(see page 26) before pairing.
To pair a baby unit:
On the idle parent unit, press
MENU.
Press or to choose PAIR/UNPAIR CAM, then press SELECT or .
Press SELECT or again to choose Pair new CAM.
Press or to choose a desired baby unit slot, then press SELECT. If
you choose an occupied baby unit slot, the new baby unit will replace the
existing baby unit.
Make sure the new baby unit is turned on. On the new baby unit,
immediately press and hold + for 8 seconds when the parent unit screen
displays Please press [+] key on CAM unit until POWER indicator
ashes Red and Green light.
When pairing is successful, the screen displays the image from the newly
paired baby unit. The AC power indicator light on the new baby unit turns
red when it is powered by AC power, or the Battery indicator light turns
green when it is powered by battery.
If pairing fails, the screen displays Pairing failed. Try the pairing
process again.
Only one baby unit can be paired at a time.
1.
2.
3.
4.
5.
6.
•
•
To Next Page
Loading...
Need help?
General
