29
Appendix
Parent unit battery
It takes up to 12 hours for the battery to be fully charged.
The standby time varies depending on the sensitivity level you set, your actual use and
the age of the battery.
The battery needs charging when:
A new battery is installed in the parent unit.
The parent unit beeps.
The battery is properly installed and no battery icon displays on the screen.
Battery low at Parent Unit and displays on the parent unit.
The light ashes on the parent unit.
CAUTION:
To reduce the risk of re or injury, read and follow these instructions:
Use only the battery provided or equivalent. To order a replacement, contact VTech
on 1 300 369 193.
Do not dispose of the battery in a re. Check with local waste management codes
for special disposal instructions.
Do not open or mutilate the battery. Released electrolyte is corrosive and may
cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.
Exercise care in handling the battery in order not to create a short circuit with
conductive materials.
Charge the battery provided with or identied for use with this product only in
accordance with the instructions and limitations specied in this manual.
Observe proper polarity orientation between the battery and metallic contacts.
To prevent re or shock hazard, do not expose this product to water or any type
of moisture.
•
•
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
