VTech IS8152-5 User Manual

22
Find handset
Use this feature to find the system handset.
To start paging:
• Press FIND HS on the telephone base when not in use.
All idle handsets ring and display ** Paging **.
To end paging:
• Press HOME/FLASH, , or any dialing key (0-9, TONE )
on the handset(s).
-OR-
• Press FIND HS, MUTE, CANCEL or STOP on the telephone
base.
N OTES
• Press MUTE to turn off the ringer of a handset temporarily. Paging
tone continues on the other handset.
• Do not press and hold FIND HS for more than four seconds. It may
lead to handset deregistration. If the handset displays To register
HS and See manual, refer to the Register a handset section to
register the handset back to the telephone base.
Redial list
The telephone base and each handset store the last 10
dialed numbers (up to 30 digits each) in the redial list. The
redial entries of each handset and the telephone base are
independent.
Review a redial list entry
To review the redial list of a handset:
1. Press REDIAL/PAUSE in idle mode.
2. Press q CID, p or REDIAL/PAUSE repeatedly to browse
through the list. The handset beeps twice at the end of the
list.
3. Press OFF/CANCEL to exit.
To review the redial list of the telephone base:
1. Press REDIAL/PAUSE in idle mode.
2. Press q CID, p or REDIAL/PAUSE repeatedly to browse
through the list. The telephone base beeps twice at the
end of the list.
3. Press CANCEL to exit.
Dial a redial list entry
To dial a redial entry on a handset:
1. Press HOME/FLASH, or to use the home line, then
press REDIAL/PAUSE to enter the redial list.
2. Press q CID, p or REDIAL/PAUSE repeatedly to browse
until the desired number displays. The handset beeps
twice at the end of the list.
3. Press DIAL to dial the number displayed.
-OR-
1. Press CELL 1 or CELL 2 to use the cell line, then press
REDIAL/PAUSE to enter the redial list.
2. Press q CID, p or REDIAL/PAUSE repeatedly to browse
until the desired number displays. The handset beeps
twice at the end of the list.
3. Press INSERT to insert the desired number.
4. Press DIAL to dial the number displayed.
-OR-
You can also select a redial entry before dialing.
1. Press REDIAL/PAUSE in idle mode.
2. Press q CID, p or REDIAL/PAUSE repeatedly to browse
until the desired number displays. The handset beeps
twice at the end of the list.
3. Press HOME/FLASH, or to call using the home line,
or CELL 1, CELL 2 to call using the cell line.
-OR-
You can insert the area code to the redial number before
dialing.
1. Enter the area code in idle mode, then press
REDIAL/PAUSE.
2. Press q CID, p or REDIAL/PAUSE repeatedly to browse
until the desired number displays, then press INSERT. The
area code will be added in front of the selected redial
number.
3. Press HOME/FLASH, or to call using the home line,
or CELL 1, CELL 2 to call using the cell line.

VTech IS8152-5 Specifications

General

Brand	VTech
Model	IS8152-5
Category	IP Phone
Language	English