52
-OR-
1. When the telephone is in idle mode, press MENU to enter
the main menu.
2. Press SELECT to select Answering sys.
3. Press SELECT again to select Announcement.
4. Press q CID or p to scroll to Reset annc, then press
SELECT. The screen shows Reset to default annc?.
5. Press YES to confirm. The screen shows Annc. reset to
default.
When your announcement is deleted, the system answers calls
with the default announcement (see Default announcement).
You cannot delete the default announcement.
Voice guide to set Answering system
This feature is an alternative way for you to do the basic setup
of the answering system. You can follow the voice guide to
record your own announcement, set the number of rings, and
set the message alert tone.
Using a cordless handset or the telephone base:
1. Press MENU when the phone is not in use.
2. Press q CID or p to choose Answering sys, and then
press SELECT.
3. Press q CID or p to choose Voice guide, and then
press SELECT. You hear a voice prompt, “This voice guide
will assist you with the basic setup of your answering
system.“
4. Set up your answering system by inputting designated
numbers, as instructed in the voice guide.
N OTES
• You can press OFF/CANCEL on the handset or press CANCEL on
the telephone base to quit the voice guide at any time.
• If the system does not receive any input, it will play an alert
message. If there is still no input, it will announce “Sorry, I still have
not received any input. If you want to restart the voice guide,
please enter the menu and select Voice guide under Answering
system. Good bye.”
• After a power outage, the system prompts you to set the date and
time, and Smart call blocker. After that, the system prompts if you
want to set up the answering system via voice guide. Press YES to
start the setup.
To Next Page
Loading...
Need help?
General
