VTech IS8152-5 User Manual

53
Set number of rings
You can set the answering system to answer an incoming call
after two, three, four, five or six rings. You can also select toll
saver. If toll saver is selected, the answering system answers a
call after two rings when you have new messages, and after
four rings when there are no new messages. This feature allows
you to check for new messages and avoid paying long distance
charges when calling from out of your local area. By default,
the answering system answers an incoming call after four rings.
To set the number of rings:
Using a cordless handset:
1. When the telephone is in idle mode, press MENU to enter
the main menu.
2. Press q CID or p to scroll to Answering sys, then press
SELECT.
3. Press q CID or p to scroll to Ans sys setup, then press
SELECT.
4. Press q CID or p to scroll to # of rings, then press
SELECT.
5. Press q CID or p to choose among 2, 3, 4, 5, 6 or Toll
saver.
6. Press SELECT to save the setting. You hear a confirmation
tone.
Using the telephone base:
1. When the telephone is in idle mode, press MENU to enter
the main menu.
2. Press SELECT to select Answering sys.
3. Press q CID or p to scroll to Ans sys setup, then press
SELECT.
4. Press q CID or p to scroll to # of rings, then press
SELECT.
5. Press q CID or p to choose among 2, 3, 4, 5, 6 or Toll
saver.
6. Press SELECT to save the setting. You hear a confirmation
tone.
N OTES
• If you set the number of rings for the answering system as 2 or 3
rings, the caller ID announce feature may not have enough time to
announce the caller’s full information.
• If Smart call blocker is on, the first ring of all incoming calls will be
muted.
Set recording time
You can set the recording time allowed for incoming messages.
The message length is three minutes by default.
To change the setting:
Using a cordless handset:
1. When the telephone is in idle mode, press MENU to enter
the main menu.
2. Press q CID or p to scroll to Answering sys, then press
SELECT.
3. Press q CID or p to scroll to Ans sys setup, then press
SELECT.
4. Press q CID or p to scroll to Recording time, then press
SELECT.
5. Press q CID or p to choose 3 minutes, 2 minutes or 1
minute, then press SELECT to save the setting. You hear a
confirmation tone.
Using the telephone base:
1. When the telephone is in idle mode, press MENU to enter
the main menu.
2. Press SELECT to select Answering sys.
3. Press q CID or p to scroll to Ans sys setup, then press
SELECT.
4. Press SELECT to select Recording time.
5. Press q CID or p to choose 3 minutes, 2 minutes or 1
minute, then press SELECT to save the setting. You hear a
confirmation tone.

VTech IS8152-5 Specifications

General

Brand	VTech
Model	IS8152-5
Category	IP Phone
Language	English