Service Notes
Information contained in this publication was in effect at the time the publication
was approved for printing and is subject to change without notice or liability.
Meritor WABCO reserves the right to revise the information presented or to
discontinue the production of parts described at any time.
Meritor WABCO Maintenance Manual 34 (Revised 03-16)
About This Manual
This manual contains maintenance procedures for Meritor WABCO’s
System Saver Series single cartridge air dryers.
Before You Begin
1. Read and understand all instructions and procedures before
you begin to service components.
2. Read and observe all Warning and Caution hazard alert
messages in this publication. They provide information that can
help prevent serious personal injury, damage to components,
or both.
3. Follow your company’s maintenance and service, installation,
and diagnostics guidelines.
4. Use special tools when required to help avoid serious personal
injury and damage to components.
Hazard Alert Messages and Torque
Symbols
Warnings are included to alert the user that possible hazards
are associated with the processes/procedures described.
These may cause death or injury in any form, if the
instructions in the operational or procedural task are not
followed precisely. Warnings describe the potential hazards
and possible impact that could occur if the warnings are not
observed.
Cautions are included to alert the user than damage to the
equipment is possible if the instructions in the operational or
procedural task are not followed precisely. Cautions describe
the hazards and possible impact that could occur if the
cautions are not observed.
@ This symbol alerts you to tighten fasteners to a specified torque
value.
NOTE: Notes are included to provide the user with supplemental
information, which is helpful but does not necessarily belong in the
core text. Many operational and procedural tasks are easier with the
addition of notes.
How to Obtain Additional Maintenance,
Service and Product Information
Visit Literature on Demand at meritor.com to access and order
additional information.
Contact the Meritor OnTrac™ Customer Call Center at
866-668-7221 (United States and Canada); 001-800-889-1834
(Mexico); or email OnTrac@meritor.com.
If Tools and Supplies are Specified in
This Manual
Contact Meritor’s Commercial Vehicle Aftermarket at
888-725-9355.
To Next Page
Loading...
Need help?
General
