Operation 5
BA TH412 * 06/2017 * 4512_5-14_Stilllegung_en.fm
5-113
5.14 Putting out of operation/back into operation
Putting the machine out of operation
The measures indicated below refer to putting the
machine out of operation and back into operation again
after a longer period of time.
1. Parking the vehicle
➥
Securing the vehicle on page 5-14.
2. Jack up the machine so that the tires do not touch the
ground any more.
3. Release the parking brake.
4. Fully lower the loader unit.
5. Reduce the residual pressure in the hydraulic system
as described in chapter
Releasing residual pressure in
the hydraulic system on page 5-82 and move all
control levers and rocker switches to neutral.
6. Spray an anticorrosion agent onto bare metal parts of
the machine (for example piston rods of hydraulic
cylinders if they are not retracted).
7. Preserve the engine.
Preserving the engine
1. Clean the engine with a high-pressure cleaner in a
suitable place.
2. Bring engine up to operating temperature.
3. Drain the engine oil and dispose of it in an
environmentally friendly manner.
4. Fill anti-corrosion oil into the engine.
5. Drain the fuel from the tank.
6. Create a mixture of 90 % fuel and 10 % anti-corrosion
oil and fill it into the fuel tank.
7. Run the engine at idling speed for 10 minutes and then
stop it.
8. Crank the engine several times by hand to preserve
the cylinders and combustion chambers.
9. Remove the fan belt and wrap it airtight und light-proof
for storage.
10.Spray an anticorrosion agent onto the running
surfaces of the pulleys.
11.Close the intake and exhaust openings of the engine.
Operation
To Next Page
Loading...
Need help?
General
