8
EN
PARTS AND COMPONENTS
150 / 170 190
SPRAY
PRIME
SPRAY
PRIME
5
1
6
2
7
13
3
4
5
1
6
2
7
3
4
4
8
10
9
11
12
SPRAY
PRIME
# ITEM DESCRIPTION
1 Tool box The Tool Box provides a place for items such as extra spray tips or wrenches.
2 Pressure control knob /
ON/OFF switch
The pressure control knob regulates the amount of force the pump uses to push the uid and can be
adjusted for desired spray pattern. Also used to switch the pump ON / OFF.
3 Spray hose port The connection between the pump and the spray hose.
4 PRIME/SPRAY knob The PRIME/SPRAY knob directs material to the material return tube when set to PRIME or to spray hose
when set to SPRAY.
5 Suction tube The suction tube draws the uid from the original container into the pump.
6 Material return tube Fluid is sent out through the return tube and back into the original container when the PRIME/SPRAY
knob is in the PRIME position.
7 Inlet lter The inlet lter is designed to prevent any debris that may be in the spray material from entering the pump.
8 Spray gun The spray gun controls the delivery of the material being pumped.
9 Tip guard The spray guard reduces the risk of injection injury.
10 Spray tip The spray tip atomizes the spray material and forms the spray pattern.
11 Hose restraint This retains the hose for easier use and storage.
12 Spray hose The spray hose connects the spray gun to the pump.
13 Pusher stem The pusher stem is designed to free the inlet valve which may become stuck due to dried materials. The
pusher stem is activated manually by the user.
To Next Page
Loading...
Need help?
General
