EasyManuals Logo
Home>Watts>Boiler>Aerco Benchmark Series

Watts Aerco Benchmark Series Installation And Start-Up Manual

Watts Aerco Benchmark Series
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
Benchmark Platinum-Edge [ii]: Installation Manual
SECTION 2 INSTALLATION
OMM-136_E • GF-210 12/13/2019 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 36 of 57
Figure 2-11: Secondary Power Panel Terminals
Figure 2-12: I/O Board Cable Connections
2.11.1 I/O Board Connections
The I/O board contains the terminal listed below, arranged on removable, named connector
strips J3 through J7 and J14, plus Molex connectors for unit harnesses. The maximum gauge
of wires connecting to the I/O board is 14.
J24
SPARK MONITOR
FROM SHELL
HARNESS 63216-2
CONNECTOR J9
VALVE HARNESS
INTERLOCK FROM SHELL
HARNESS 63216-2
J6 PINS 3 & 4
DUAL FUEL SWITCH
HARNESS 63239
(DUAL FUEL ONLY)
CONNECTOR J10
LOW WATER CUTOFF JUMPER
CONNECTOR J8
40 PIN RIBBON I/O
HARNESS 63220
CONNECTOR J1
30 PIN RIBBON I/O HARNESS 63221
CONNECTOR J2
I/O BOARD POWER
HARNESS 63232
CONNECTOR J24
FLOW SENSOR
4-20mA OUT
AIR PUMP
(AIR EDUCTOR ON BMK5000 &
6000 ONLY)
BLOCKED FLUE
SWITCH
BLOWER RELAY
PUMP RELAY
OXYGEN SENSOR
12 V
Ground
J9
AC Hot
AC Neutral
Neutral
Ignition
Transformer
Current Sense
Line Voltage
Ignition Transformer

Other manuals for Watts Aerco Benchmark Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Watts Aerco Benchmark Series and is the answer not in the manual?

Watts Aerco Benchmark Series Specifications

General IconGeneral
BrandWatts
ModelAerco Benchmark Series
CategoryBoiler
LanguageEnglish

Related product manuals