Webasto UniControl User Manual

8
3.3.1 Back-function
Back
Exit the selected menu with the "Back" function.
The settings are saved and the higher-level menu level is displayed.
3.4 Status display
Status of the heater is indicated by means of the colour backlight of the quick start
button.
Status LED backlight
Heating mode GREEN permanent
Ventilation mode BLUE permanent
Switched off heater - control element is activated WHITE permanent
Error - no heating mode, see chapter „11 Error mes-
sage“ on page 26.
RED flashing
Preprogrammed heating mode - control element in
stand-by mode
GREEN flashing
Preprogrammed ventilation mode - control element in
stand-by mode
BLUE flashing
If a user does not make any entry by means of the control element for 60
seconds and the heater is switched off then the control element will go into
the stand-by mode (display and LED are switched off).
3.5 Passive display mode
If the heater is activated by another Webasto control element (e.g. Telestart or Thermo-
call), the control element wakes up from sleep mode and the operation mode selected
by the other control element is shown on the display. Displayed information depends on
the connected heater.
Display Operating mode
Heating

The passive mode can be deactivated by pressing quick start button
. The heater is switched off.

Webasto UniControl Specifications

General

Brand	Webasto
Model	UniControl
Category	Controller
Language	English