25
9.10 Displaying the system information
There are data in the system information regarding software status and control element
status and the name of the connected heater.
3
The menu element "Settings" has been chosen.
Turn the control knob in order to choose menu element
“System information”.
System
information
Settings
Press the control knob in order to confirm selection.
The heater name is shown in the display.
Heater
Settings
Turn the control knob in order to switch between the names
of the heater and information regarding control element
(the name of the control element, status of software and
equipment).
9.11 Displaying stored error information
If heaters and other connected components show malfunctioning then such error
information codes) is saved and displayed here. Current error information is additionally
marked with “!” symbol.
When an error occurs, error information must be confirmed by pressing the control
knob. The main menu is displayed once again only after confirmation.
3
The menu element "Settings" has been chosen.
Turn the control knob in order to choose menu element
“Error message”.
Error
information
Settings
Press the control knob in order to confirm selection.
Error message(s) is (are) shown in the display. If there is no
error message then “OK” appears in the display. If there are
more error messages then all the messages can be displayed by
turning the control knob.
Press the control knob in order to return to menu element.
To Next Page
Loading...
Need help?
General
