Weiss Enginering Ltd. DSP501/DSP502
2 Quick Start Guide
This Quick Start Guide presents the first steps to set up the DSP50x unit. Further and more detailed informations
about the DSP50x and its features can be found in the DSP501/DSP502 User Manual and White Papers.
2.1 Setting up the DSP50x hardware
Carefully unpack the DSP50x unit. The following items should be included:
• The DSP50x unit
• This quick start guide with a warranty card
• An IR remote control unit
Figure 3: The back panel of the DSP501
After unpacking the DSP50x connect the necessary input/output cables at the back of the unit.
Also connect the mains cable. The mains voltage is automatically sensed by the DSP50x. Mains voltages
between 90V and 240V are allowed. No manual mains voltage selection is necessary.
To switch on the unit press on the rotary knob on the faceplate or press the power on/off button on the IR remote
(upper/left corner). Wait for about half a minute for the unit to boot.
Note: Most of the parameters mentioned below can also be set via the DSP50x’s web interface. If you have
connected your DSP50x with an Ethernet cable to a router unit you may access the DSP50x via web browser.
Enter this URL into your browser:
• dsp501-nnnn.local (for a DSP501 unit) or dsp502-nnnn.local (for a DSP502 unit)
• nnnn is the serial number of your DSP50x unit. You see that number on the back of the unit.
The first steps with your DSP50x 2 Quick Start Guide
To Next Page
Loading...
Need help?
General
